How to perform an ATP Quick Test


  1. To get started, touch the Quick Test button from the EnSURE Touch home screen.

  1. This will take you to the screen displayed below.

When you’re ready to measure an activated ATP test device, hold the EnSURE Touch device upright and open the lid. Drop in the activated test swab and close the lid. Confirm that the correct test device is selected on the screen and press the Run Test button. To get an accurate reading, you

must hold the EnSURE Touch device upright during testing.

Click here for detailed instructions on how to use the UltraSnap swabs.


  1. Select a Device Type. No need to enter any custom fields as you will track this in your Walsh QA system. Touch Run Test to begin the Quick Test.



Performing a Retest


On the results screen of a test, you have the option to perform a retest. If you would like to come back and retest at a later time, you can do this from the Retest option on your home screen. When you perform a retest, the new test result is tied to the original test so that you can easily prove that corrective actions took place and that they were effective.


  1. Open the Retest app from the home screen.


  1. Touch 1 to reorder your failed results either ascending or descending.

    Touch 2 to delete results you don’t plan on retesting.

    Touch a failed test result (as shown at 3 in the image) to see detailed information and perform a retest.


If you touch 3 to see detailed information on the current failed result you’ll see a screen like below. It will show you information such as the date, time, plan, and location of the failed test result. When you’re ready to retest, touch the Retest button.



RLU's


Hygiena luminometers are preset with Pass and Fail RLU limits that are based on industry standards and published study recommendations.

Note: You can customize your RLU's by selecting Settings->Customization->Product Selections->Default Limits